Partner Tech P200107HRB User Manual download pdf (Page 22)

02306

277

02330

To install bagger com po nents to tractor

1. Dis charge Chute

2. 3/8 Nut

3. Flat Washer

1. 3/8 Lock nut

2. Flat Wash er

3. Support Tube

1. Support Bracket

2. Clevis Pin 10 x 17mm

3. 3/8 Lock Nut

4. 3/8 x 63,5mm Hex Bolt

5. 10,3mm (13/32") flat

washer

6. Retainer Spring

1. Hook

2. Discharge Chute

3. Back plate slot

• Remove discharge chute from rear of tractor. Unhook the

two (2) straps and pull chute out and away from tractor.

• Remove the two (2) 3/8 nuts and flat washers from the

bolts at the tractor back plate.

• Using the nuts and flat washers removed from tractor

back plate, install the bagger support tube to the back

plate as shown. Tighten securely.

• Install the two upper support brack ets through the back

plate and to the chas sis, install the clevis pin 10x17mm

and secure with retainer spring.

• Assemble both support brackets to the outside of the

bagger support tube using two each 3/8 x 63,5mm hex

bolts13/32" I.D. flat washers and 3/8 locknuts from parts

bag. Tight en securely.

• Replace discharge chute into rear opening of tractor.

Secure the chute with the two hook straps.

NOTE: The strap hook must go through the discharge chute

only. Do not allow the hook to enter the slot in the tractor

back plate. This will allow the dis charge chute to float with the

mower deck when moving on uneven terrain.

3028

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 87 88

No comments

Partner Tech P200107HRB User Manual Page 22